Special shirt, Special 79

Thanks to Jay Roche for the Badass t-shirt. Spcl 79 Fabrications rocks!

Aluminum exhaust for RCVC

Made these sick lil pipes for a old school sears moped my buddy Matty at Rubber City Vintage Cycles is putting together. Dirty lil suckers!

Chop shop!

Been doin quite a few hardtails. The Leftovers.

59' Sporty Fender Struts

Rolled a 5 foot piece of 3/8" in my 3 wheel roller. Counter sunk some bungs for 3/8" Allen heads bolts, I also Tig welded 1/4" thick 3/8" coarse thread bungs on the inside of the fender, so no need to hold back on a nut with the tire on! So far so good.           

59' bmx barz

Whipped these up for my buddy Chris. They are 1" .120 wall dom bent just past 90 degrees and the center piece is 2 pieces slugged then welded together and cleaned up. Turned out sweet

Come check me out on instagram

At austin_martin_originals

Screw buying a brake linkage!

Took the stock rear section of Kurt's xs and chopped the stock brake pedal pivot out. Shaped it how I wanted. Cut some 1"x1/8" flat stock to box it in, tacked the pieces in then finish welded it with the Tig. Slapped it on the frame were the pedal looked like it would work and so the mount wouldn't interfere with the motor being put in and taken out. Mig welded it to the frame just have to extend the stock linkage and buff the weld down alil. That is in part two of linkage extension.

Kurt's XS

This 81' is on its way to being fine piece of machinery. These are some of the things we knocked out today. Put the proper spacers in to accommodate the rear hardtail and stock wheel. Cut a seat mount gusset, set the motor in (which every motor mount slid in like butter), mocked the mid controls, line the rear tire up and cut the chain length. Also cut the biltwell seat hinge to work on a flat surface. Lastly I cut the monster craftsman chain tensioner in half and extended it an inch to avoid any spring back problems down the road.